Hp ProLiant ML350p Gen8 Server Instrukcja Użytkownika Pobierz pdf (Strona 53)

Hardware options installation 53

For rack models, if removed, install the security bezel (on page 21).

Processor upgrade

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the

internal system components to cool before touching them.

CAUTION: To prevent possible server malfunction and damage to the equipment, multiprocessor

configurations must contain processors with the same part number.

CAUTION: The heatsink thermal interface media is not reusable and must be replaced if the

heatsink is removed from the processor after it has been installed.

IMPORTANT: Processor socket 1 must be populated at all times or the server does not function.

To remove the component:

1. Do one of the following:

o For tower models, open and remove the bezel ("Remove the tower bezel" on page 21).

o For rack models, if installed, remove the security bezel (on page 21).

2. Power down the server (on page 20).

3. Remove all power:

a. Disconnect each power cord from the power source.

b. Disconnect each power cord from the server.

4. Do one of the following:

o For tower models, place the server on a flat, level surface with the access panel facing up.

o For rack models, extend the server from the rack (on page 24).

5. Remove the access panel (on page 23).

6. Remove the air baffle (on page 25).

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 144 145

Brak uwag

Hp ProLiant ML350p Gen8 Server Instrukcja Użytkownika Strona 53