Hp Netserver L Server series Instrukcja Użytkownika Pobierz pdf (Strona 71)

Chapter 7 Rack Mounting the HP Netserver (2-Post)

Preparing the HP Netserver

Each HP Netserver has two inner-rails attached at the factory and shipped to

customers. These two inner-rails must be removed to attach the brackets before the

Netserver can be mounted in the rack.

1. Lay the HP Netserver on a flat surface.

2. Remove the front bezel on the Netserver chassis, if not already removed.

See Figure 7-3.

Optional (2)

Figure 7-3. Removing Existing Hardware

3. Remove the screws holding the inner-rails and spacers on each side of the

chassis. See Figure 7-3.

4. If mounting flush mount brackets, remove the screws holding the front

mounting brackets to each side of the chassis. See Figure 7-3.

5. Locate the brackets in the kit.

a. If you are mounting the HP Netserver as a flush mount, you only need the

two flush mount brackets mounted on the front of the chassis.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 139 140

Brak uwag

Hp Netserver L Server series Instrukcja Użytkownika Strona 71