Hp TouchSmart 9300 Elite All-in-One PC Instrukcja Użytkownika Strona 1

Wall-Mounting your HP TouchSmartUser Guide

8. Lift the computer stand away from the computer.9. Save the computer stand, stand cover, and four screws, so that you can convert yourHP TouchSmart

Installing the VESA adapter plate1. Place the VESA adapter plate over the rails on the back of the computer, matching the cutouts onthe each side of t

3. Slide the VESA adapter plate upward until it locks into place. You will hear a click when the VESAadapter plate is locked in place.NOTE: If you do

4. Attach the wall-mounting hardware (purchased separately) to the VESA adapter plate, accordingto the manufacturer's instructions, using either

2 Reinstalling the stand on yourHP TouchSmart PCYou may decide to convert your HP TouchSmart PC from a wall-mounted unit back to a desktop unit.You wi

Removing the wall-mounting hardwarePrepare your HP TouchSmart PC for removal from the wall-mounting device.1. Remove any media and external devices (s

Replacing the computer standReplace the computer stand on your HP TouchSmart PC. Once the computer stand is on the computer,replace the VESA adapter p

3. Tilt the base of the computer stand so that you can position it over the rails on the back of thecomputer, and align the four screw holes.4. Use a

5. Use a Phillips screwdriver to loosen the brake screws, turning to the left 5–6 times.NOTE: The brake screws are not removable and only need to be l

7. Position the VESA adapter plate over the bottom of the computer stand, aligning the round cutoutwith the raised circle, and align the four screw ho

The only warranties for Hewlett-Packardproducts and services are set forth in theexpress statements accompanying suchproducts and services. Nothing he

9. Align the stand cover to the computer stand and snap it back into place. Make sure that there areno gaps between the computer stand and the stand c

Table of contents1 Preparing your HP TouchSmart PC for wall-mounting ... 1What you need ...

iv Wall-Mounting your HP TouchSmart

1 Preparing your HP TouchSmart PCfor wall-mountingThis document provides instructions for computer wall-mounting preparation. The VESA adapter plate i

Before removing the standTo avoid injury and equipment damage when opening the HP TouchSmart PC, always complete thefollowing steps in order:1. Remove

2. Insert your finger, or a flathead screwdriver, into the slot on the stand cover to pry it off of thecomputer stand.3. Remove the stand cover from t

4. Use a Phillips screwdriver to tighten the recessed two brake screws (for the rails) on the computer.It should take about 5–10 turns of the screwdri

6. Remove the VESA adapter plate from the bottom of the computer stand.7. Use a flathead screwdriver to remove the four screws attaching the computer