Hp OmniBook XE2-DB Notebook PC Instrukcja Użytkownika Pobierz pdf (Strona 31)

Using the OmniBook

Expanding the OmniBook

Setup Guide 31

To replace a hard disk drive

You’ll need a small Phillips screwdriver to complete this procedure.

1. From the Start menu, shut down the OmniBook.

2. Unplug the AC adapter, if present, and remove the battery.

3. Turn the unit bottom side up.

4. Use a screwdriver to remove the hard disk drive locking screw.

5. Slide and hold the hard disk drive latch.

6. Slide the hard disk drive toward the edge of the OmniBook, then lift out.

7. Insert the new hard disk drive and the locking screw.

8. Insert the battery.

If you are installing a new hard disk drive, you should create a Hibernate partition

on the drive before loading any software—see the instructions included with the

drive or go to the OmniBook website at www.hp.com/omnibook.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 77 78

Brak uwag

Hp OmniBook XE2-DB Notebook PC Instrukcja Użytkownika Strona 31