HP 6631B Instrukcja Użytkownika Strona 22

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 75
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 21
3 - Installation
22
Location
The outline diagram in figure 3-1 gives the dimensions of your dc source. The dc source must be
installed in a location that allows sufficient space at the sides and back of the unit for adequate air
circulation (see Bench Operation).
Bench Operation
A fan cools the dc source by drawing air in through the sides and exhausting it out the back.
Minimum clearances for bench operation are 1 inch (25 mm) along the sides. Do not block the fan
exhaust at the rear of the unit.
Rack Mounting
The dc source can be mounted in a standard 19-inch rack panel or cabinet. Table 2-1 documents
the HP part numbers for the various rack mounting options that are available for the dc source.
Installation instructions are included with each rack mount option.
NOTE: Support rails or an instrument shelf is required when rack mounting units.
Figure 3-1. Outline Diagram
Przeglądanie stron 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 74 75

Komentarze do niniejszej Instrukcji

Brak uwag