HP Z600 Dokumentacja Strona 176

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 175
Problem Cause Solution
a. Disconnect AC power.
b. Remove the power supply.
c. Plug in AC power.
If the power supply fan spins and the LED
illuminates (see
Testing power supply
on page 163), the power supply is good.
Replace the system board.
If the power supply fan does not spin or the
LED does not illuminate (see
Testing
power supply on page 163), replace the
power supply.
Solving diskette problems
Table 6-3 Diskette problems
Problem Cause Solution
Diskette drive light stays on. Diskette is damaged.
1. Right-click Start, select Explore, and then select a
drive.
2. Select File>Properties>Tools.
3. Under Error-checking, select Check Now.
Diskette is incorrectly inserted. Remove and reinsert diskette.
Files on the diskette are
damaged.
Verify the program diskettes.
Drive cable is not properly
connected.
Reconnect the power cable and verify that all four pins
are connected.
Drive not found. Cable is loose. Reseat the diskette drive data and power cables.
Removable drive is not seated
properly.
Reseat the drive.
Diskette drive cannot write to a
diskette.
Diskette is not formatted. Format the diskette.
Diskette is write-protected. Use another diskette or remove the write protection.
Writing to the wrong drive. Verify the drive letter in the path statement.
There is not enough space on
the diskette.
Use another diskette.
Diskette write-control is
enabled.
Use the Computer Setup (F10) Utility to verify the storage
security feature disabled settings.
Diskette is damaged. Replace the damaged disk.
Cannot format diskette. Invalid media reported. When formatting a disk in MS-DOS, you might need to
specify diskette capacity.
For example, to format a 1.44-MB diskette, enter the
following command at the MS-DOS prompt: FORMAT
A: /F:1440
Table 6-2 Power supply problems (continued)
164 Chapter 6 Diagnostics and troubleshooting ENWW
Przeglądanie stron 175
1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 237 238

Komentarze do niniejszej Instrukcji

Brak uwag