HP Z800 Dokumentacja Pobierz pdf (Strona 114)

Installing an optical disk drive in the optical drive bay

Disconnect power from the workstation (see

Predisassembly procedures on page 77).

Remove the side access panel (see

Removing the side access panel on page 79).

Remove the airflow guide (see

Removing the airflow guide on page 80).

If you are adding an additional drive, remove the filler tray (see

Removing a filler tray

on page 97).

NOTE: Unused optical bay power cables are stored in this tray.

Lift and hold the drive release latch at the green touch point (1) while sliding the optical disk drive

into the bay (2). When the front of the drive is near its final position, release the latch, but

continue to slide the drive inward until the latch closes and engages the drive.

TIP: An optical drive longer than 175 mm (but less than 206 mm) must be installed in the middle

or bottom bay.

Figure 5-26 Installing the optical disk drive

TIP: During installation the adjacent drive or filler may move slightly. You might have to slide

and align both devices to get the release latch to close and engage both devices.

102 Chapter 5 Replacing components ENWW

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 303 304

Brak uwag

HP Z800 Dokumentacja Strona 114