HP X09 Instrukcja Obsługi Pobierz pdf (Strona 25)

XStream‐PKG‐E™EthernetRFModem–ProductManualv5.x00[2006.02.24]

CD (DO3 Configuration) Command

AT Command: ATCD

Binary Command: 0x28 (40 decimal)

Parameter Range: 0 – 2

Parameter Configuration

0 RX LED

1 Default high

2 Default low

3 (reserved)

4

Assert only when packet

addressed to module sent

Default Parameter Value: 0

Number of bytes returned: 1

Minimum Firmware Version Required: 4.2B

<Command Mode Options> CD Command is used

to redefine the behavior of the DO3/RX LED line.

CE (Connection Inactivity Timeout) Command

AT Command: ATCE

Binary Command: 0x34 (52 decimal)

<Networking & Security> Set/Read the duration

of inactivity that will cause a break in a

connection between modems. The base modem

will disconnect when no payload has been

transferred for the time specified by the CE

parameter.

Parameter Range: 0 – 0xFFFF

[x 10 milliseconds]

Default Parameter Value: 0x64 (1d second)

Number of bytes returned: 2

Related Commands: CB ( Connection Duration

Timeout), DC (Disconnect), MD (RF Mode)

Minimum Firmware Version Required: 4.30

CF (Connection Failure Count) Command

AT Command: ATCF

Binary Command: 0x35 (53 decimal)

Parameter Range: 0 – 0xFFFF

Default Parameter Value: 0

Number of bytes returned: 2

Minimum Firmware Version Required: 4.30

<Diagnostics> Set/Read the number of times the

base modem expired retries attempting to send a

Connection Grant Packet.

Set the parameter value to zero to clear the

register.

CL (Last Connection Address) Command

AT Command: ATCL

Binary Command: 0x39 (57 decimal)

Parameter Range: 0 – 0xFFFF [read-only]

Number of bytes returned: 2

Minimum Firmware Version Required: 4.30

<Diagnostics/Networking & Security> Read the

address of the remote modem that last

connected to the base modem. A remote modem

will return its DT (Destination Address)

parameter.

CM (Connection Message) Command

AT Command: ATCM

Binary Command: 0x38 (56 decimal)

Parameter Range: 0 – 1

Parameter Configuration

0 enable

1 disable

Default Parameter Value: 0

Number of bytes returned: 1

Minimum Firmware Version Required: 4.30

<Networking & Security> Select whether base

sends connect messages to the host when a

connection is established. When enabled, a

“CONNECTXXXX” string is sent to the host of the

base modem. “XXXX” is the MY (Source Address)

of the connected remote modem.

©2006MaxStream,Inc.ConfidentialandProprietary 25

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 55 56

Komentarze do niniejszej Instrukcji

Brak uwag