HP Compaq dc5800 Podręcznik Użytkownika Pobierz pdf (Strona 38)

10. Press down on the green drive retainer button located on the left side of the drive to disengage the

drive from the drive cage (1). While pressing the drive retainer button, slide the drive back until it

stops, then lift it up and out of the drive cage (2).

Figure 2-25 Removing the Optical Drive

NOTE: To replace the optical drive, reverse the removal procedure. When replacing a drive, transfer

the four guide screws from the old drive to the new one.

Installing an Optical Drive into the 5.25-inch Drive Bay

To install an optional 5.25-inch optical drive:

1. Remove/disengage any security devices that prohibit opening the computer.

2. Remove all removable media, such as diskettes or compact discs, from the computer.

3. Turn off the computer properly through the operating system, then turn off any external devices.

4. Disconnect the power cord from the power outlet and disconnect any external devices.

CAUTION: Regardless of the power-on state, voltage is always present on the system board as

long as the system is plugged into an active AC outlet. You must disconnect the power cord to

avoid damage to the internal components of the computer.

5. If the computer is on a stand, remove the computer from the stand.

6. Remove the access panel.

7. If you are installing a drive in a bay covered by a bezel blank, remove the front bezel then remove

the bezel blank. See

Removing Bezel Blanks on page 13 for more information.

32 Chapter 2 Hardware Upgrades ENWW

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 69 70

Brak uwag

HP Compaq dc5800 Podręcznik Użytkownika Strona 38