HP C6240 Instrukcja Użytkownika Pobierz pdf (Strona 9)

What you need for a wired network

Before you connect the HP All-in-One to a network, make sure you have all of the required

materials.

❑

A functional Ethernet network that includes a router, switch, or hub with an Ethernet

port.

❑

CAT-5 Ethernet cable.

Although standard Ethernet cables look similar to standard telephone cables, they

are not interchangeable. There is a different number of wires in each one, and each

has a different connector. An Ethernet cable connector (also called an RJ-45

connector) is wider and thicker and always has 8 contacts on the end. A phone

connector has between 2 and 6 contacts.

❑

A desktop computer or laptop with an Ethernet connection.

NOTE: The HP All-in-One supports both 10 Mbps and 100 Mbps Ethernet

networks. If you are purchasing, or have purchased, a network interface card

(NIC), make sure it can operate at either speed.

Connect the HP All-in-One to the network

To connect the HP All-in-One to the network, use the Ethernet port on the back of the

device.

To connect the HP All-in-One to the network

1. Remove the yellow plug from the back of the HP All-in-One.

2. Connect the Ethernet cable to the Ethernet port on the back of the HP All-in-One.

Wired network setup 7

Network setup

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 34 35

Brak uwag

HP C6240 Instrukcja Użytkownika Strona 9