HP 600N Instrukcja Instalacji Pobierz pdf (Strona 18)

2-4 Installing the Print Server

Step 2. If Necessary, Set Switches or

Jumpers on Your Card

●

If you have an HP J3112A Token Ring print server

, you

must set the Data Rate switches on the card to either 4 Mbps or

16 Mbps. The selection depends on the data rate of your Token

Ring network.

a. Locate the Token Ring card Data Rate switches.

b. Set the switches to 4 or 16 Mbps. The default is 16 Mbps.

●

If you have an HP J3113A 10/100Base-TX print server

verify that jumper P1 is in the “AUTO” (Autonegotiation)

position. This is the default position. (In this position, the card

will attempt to automatically connect to the network at the

detected speed (10 or 100 Mbps) and communication mode

(Full or Half Duplex).)

Note For the definition of other jumper settings on the

10/100Base-TX card, see appendix

4 Mbps 16 Mbps

10/100; Half/Full

P1 = AUTO

Autonegotiation

S00eiohw.book Page 4 Thursday, February 24, 2000 2:26 PM

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 53 54

Brak uwag

HP 600N Instrukcja Instalacji Strona 18