HP NN124AA Arkusz Danych Strona 1

Sliding rack-mount kit installationIntroductionThis document describes how to install the sliding rack mount kit on an HP Z600 Workstation and anHP Z8

7. Attach the slide to the front of the rack using the M6 screw mounted in the slide and the remainingnut from Step 3 (7).Figure 10 Attaching the bra

Using the mounting reference guide1. Choose the appropriate mounting reference guide.●The HP Z600 Workstation requires a 4U space. The center of the r

Japanese 日本語This document is available in Japanese. See http://www.hp.com/support/workstation_manuals, thenselect your workstation product and select

Warnings and cautionsWARNING! Any surface or area of the equipment marked with this symbol indicates the presenceof an electrical shock hazard. To re

Tools requiredRound hole and square hole racks●T-15 Torx screwdriverThreaded hole racks●T-15 Torx screwdriver●Flat head screwdriver●Cross-tip screwdri

5. Remove the rear handle by using a T-15 Torx screwdriver to remove the long screw that securesthe handle (1), and then remove the handle (2).Figure

7. Lift the top cover from the chassis as shown in the following figure.Figure 3 Removing the top cover8. Reinstall the side access panel.Step 2—Inst

Step 3—Installing rails to the rack(Optional) Adjusting slides to fit shallower or deeper third-party racks1. Remove the slide adjustment attachment (

Installing on round hole and square hole HP racksThese instructions apply to racks such as standard HP racks.NOTE: To determine the appropriate alignm

Installing on threaded hole racksNOTE: To determine the appropriate alignment for a workstation that requires a 4U space (HP Z600Workstations) or a 5U

Installing on earlier HP racksNOTE: The parts for this procedure are available separately in adapter kit number WD587AA.1. Extend the rails (1).2. Rem