HP SP400 Podręcznik Użytkownika Pobierz pdf (Strona 28)

Operate the All-in-One

Print instructions

1. Locate a clean, flat surface near the bar code for printing.

2. Place the nose of the All-in-One against the surface. The All-in-One should rest at an angle of

about 7 degrees from vertical.

3. Move the All-in-One straight across the surface.

4. When the print is finished, the green light will turn off and the All-in-One will emit a Hi tone.

CAUTION: Maintain a relaxed wrist and hand posture and use low force when printing.

Printing tips

IMPORTANT:

• Keep the printer wheel continuously in contact with the print surface while printing.

Print wheel

• Hold the All-in-One so that the angle of the device to the surface is approximately 7 degrees.

• Do not push hard on the surface; light pressure will result in better prints, especially with soft

packages.

• Do not rotate your wrist. Rotating your wrist while printing can cause skipping or incomplete

prints.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 65 66

Brak uwag

HP SP400 Podręcznik Użytkownika Strona 28