HP PROCURVE 2520 Instrukcja Użytkownika Pobierz pdf (Strona 275)

100

101

Port Trunking

CLI: Viewing and Configuring Port Trunk Groups

Listing Static LACP and Dynamic LACP Trunk Data.

Syntax:

show lacp

Lists data for only the LACP-configured ports..

In the following example, ports A1 and A2 have been previously configured

for a static LACP trunk. (For more on the “Active” parameter, see table 12-5

on page 12-21.)

Figure 12-8. Example of a Show LACP Listing

(For a description of each of the above-listed data types, refer to table 12-5,

“LACP Port Status Data” on page 12-21.)

Dynamic LACP Standby Links. Dynamic LACP trunking enables you to

configure standby links for a trunk by including more than eight ports in a

dynamic LACP trunk configuration. When eight ports (trunk links) are up, the

remaining link(s) will be held in standby status. If a trunked link that is “Up”

fails, it will be replaced by a standby link, which maintains your intended

bandwidth for the trunk. (Refer to also the “Standby” entry under “Port Status”

in "Table 12-5. LACP Port Status Data" on page 12-21.) In the next example,

ports A1 through A9 have been configured for the same LACP trunk. Notice

that one of the links shows Standby status, while the remaining eight links are

“Up”.

12-13

1 2 ... 270 271 272 273 274 275 276 277 278 279 280 ... 543 544

Komentarze do niniejszej Instrukcji

Brak uwag

HP PROCURVE 2520 Instrukcja Użytkownika Strona 275

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie HP PROCURVE 2520