HP PROCURVE 6120 Instrukcja Użytkownika Pobierz pdf (Strona 272)

100

101

11-20

Port Trunking

Trunk Group Operation Using LACP

Static LACP Provides a manually configured, static LACP trunk to accommodate these conditions:

• The port on the other end of the trunk link is configured for a static LACP trunk.

• You want to configure non-default spanning tree or IGMP parameters on an LACP trunk group.

• You want an LACP trunk group to operate in a VLAN other than the default VLAN and GVRP is

disabled. (Refer to “VLANs and Dynamic LACP” on page 11-23.)

• You want to use a monitor port on the switch to monitor an LACP trunk.

The trunk operates if the trunk group on the opposite device is running one of the following trunking

protocols:

• Active LACP

• Passive LACP

• Trunk

This option uses LACP for the port Type parameter and TrkX for the port Group parameter, where X is

an automatically assigned value in a range corresponding to the maximum number of trunks the switch

allows. (The table on page 11-5 lists the maximum number of trunk groups allowed on the switches

covered in this guide.)

Displaying Static LACP Trunk Data: To list the configuration and status for a static LACP trunk, use the

CLI

show lacp command. To list a static LACP trunk with its assigned ports, use the CLI show trunk

command or display the menu interface Port/Trunk Settings screen.

Static LACP does not allow standby ports.

LACP Port Trunk

Configuration

Operation

1 2 ... 267 268 269 270 271 272 273 274 275 276 277 ... 588 589

Komentarze do niniejszej Instrukcji

Brak uwag

HP PROCURVE 6120 Instrukcja Użytkownika Strona 272

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie HP PROCURVE 6120