HP SmartCard NIPRNet Solution for US Government Instrukcja Użytkownika Pobierz pdf (Strona 13)

Congure the HP product for Kerberos Authentication

NOTE: Make sure to congure and test the Kerberos settings when the HP Smartcard reader is installed for

the rst time.

1. Open a Web browser.

For instructions, see Access the HP Embedded Web Server (EWS) on page 5

2. On the top navigation tabs, select the Settings tab.

3. On the left navigation pane, select the Kerberos Authentication tab.

Figure 3-2 Kerberos Authentication

4. On the Kerberos Authentication page, click Add, and then complete the following steps to set

parameters and credentials used to access the LDAP server:

a. In the Accessing the Kerberos Authentication Server section, type the Kerberos domain name, OR

click Advanced to access Alternate Domain Conguration.

NOTE: Most US Government agencies disable the reverse DNS lookups option.

●

Kerberos Realm: Type the Kerberos domain in upper case.

●

Kerberos Server Hostname: Type the fully qualied domain name of the Kerberos realm.

NOTE: The Kerberos Server Hostname might be the same as the Kerberos Realm if a

Domain Name Service (DNS) is available and congured correctly. If a DNS is not available, use

the IP address of the Kerberos Server.

●

Kerberos Server Port: The default port is 88.

8 Chapter 3

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 36 37

Brak uwag

HP SmartCard NIPRNet Solution for US Government Instrukcja Użytkownika Strona 13