HP SN6000 Instrukcja Użytkownika Pobierz pdf (Strona 51)

HP SAN Connection Manager User Guide 51

2. When you finish viewing the switch zoning information, click OK to close the dialog box.

NOTE: If you have transparent routing configured with IFZs activated (see “About transparent routing,”

page 47), the switch zoning information may appear in SAN Connection Manager (Figure 29). IFZs

appear as Z

ONE: IFZ_XXXXXXXXXXXXXXXX_XXXXXXXXXXXXXXXX, followed by the Port WWN of each

TR_Port, host port, and storage port. If known, the Switch Name, Port Type, and Vendor information are

shown; otherwise, this information is displayed as “Unknown.”

Figure 29 Switch Zoning Information dialog box (TR_Ports mapping)

Setting the switch default zoning

CAUTION: Altering the active zoning configuration can disrupt SAN traffic.

A zone is a named group of ports or devices. Members of the same zone can communicate with each

other and transmit outside the zone, but cannot receive inbound traffic from outside the zone. Zoning

divides the fabric for purposes of controlling discovery and inbound traffic.

Based on the HBA and storage ports connected to the switch, SAN Connection Manager can set the switch

zoning to an HBA-based zoning scheme where each HBA is in its own zone along with all the storage

ports.

Use the Set the Switch Default Zoning dialog box to set a default zone and include or exclude a device

from a zone.

NOTE: When the Set the Switch Default Zoning dialog box first opens, all the devices are included in

zones.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 161 162

Brak uwag

HP SN6000 Instrukcja Użytkownika Strona 51