Hp Unified Extensible Firmware Interface Instrukcja Użytkownika Pobierz pdf (Strona 61)

Figure 51 Server Availability — Wake On LAN screen

Configuring the POST (Power-On-Self-Test) F1 Prompt

Configure the system to display the F1 key in the server POST screen. If an error is encountered,

press the F1 key to continue with the server power-up sequence.

To configure the POST F1 prompt:

1. From the System Utilities screen, select System Configuration→BIOS/Platform Configuration

(RBSU)→Server Availability and select POST F1 Prompt and press Enter.

2. The following options are available:

• Delayed 20 Seconds— if an error occurs, the system pauses for 20 seconds at the F1

prompt, and then continues to boot the OS.

• Delayed 2 Seconds — if an error occurs, the system pauses for 2 seconds at the F1

prompt, and then continues to boot the OS.

• Disabled — if an error occurs, the system bypasses the F1 prompt and continues to boot.

3. A series of system tests executes during POST before continuing with the following:

• If failures occur that allow the system to continue operating, the system continues to boot

and then posts a message.

• If critical components fail or are missing, the server attempts to boot. If it can boot, it posts

a message and an F1 prompt.

• If the system cannot run with the missing or failed components, it halts until those

components are replaced.

4. Press F10 to save your selection.

Accessing the BIOS/Platform Configuration (RBSU) menu 61

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 157 158

Brak uwag

Hp Unified Extensible Firmware Interface Instrukcja Użytkownika Strona 61