Hp RDX Removable Disk Backup System Instrukcja Użytkownika Pobierz pdf (Strona 15)

• Mounting screws: Other HP ProLiant server models, such as M L350 and ML370, require the use

of special locating screws with no mounting rail. Use a Torx screwdriver to attach the appropriate

screws. You may need to purchase the M3 screws separately.

Other servers

Attach the appropriate mounting hardware. Refer to the manufacturer’s d ocumentation for i nstructions.

• If you are installing on a server that requires a tray, place the RDX Removable Disk Backup

System in the t

ray.

• If you are installing in a server that requires mounting rails, fasten the rails to the RDX Removable

Disk Backup System.

• Some servers

have snap-on mounting rails attached to the ﬁller panel. These can be removed and

attached to the RDX Removable Disk B ackup System with screws.

Install drive

Slide the RDX Removable Disk Backup System into the open bay, aligning the tray or rails with the slots

in the bay, as shown in Figure 3 on page 15.

Figure 3 Installing RDX Removable Disk Backup System

If your server does not use m ounting hardware, check that the holes in the chassis are aligned with the

holes in the side of the RDX Removable Disk B ackup System.

Do not secure the RDX Removable Disk Backup System at this point because you may have to move it

to get the cables into place.

RDX Removable Disk Backup System

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 37 38

Brak uwag

Hp RDX Removable Disk Backup System Instrukcja Użytkownika Strona 15