Hp StorageWorks XP10000 Disk Array Instrukcja Użytkownika Pobierz pdf (Strona 116)

3. Right-click any point in the Authentication Information (Host) list, and select Add New User

Information. The Add New User Information (Host) pane appears.

Figure 63 Add New User Information (Host) pane

Specify the following user information for the host you want to allow to connect:

• Group Name:

Host bus adapter's group name. Select one from the list. All group names of

host bus adapters connected to the selected port by the cable appear in the list.

• User Name: Host bus adapter's WWN, up to 16 characters. You can use alphanumeric

character

sinausername.

• Secret: Secret (that is, a password used in CHAP authentication) between 12 to 32 characters.

You can use alphanumeric characters, spaces, and the following symbols in a secret:

.-+@_=:/[],~

• Re-enter

Secret: Specify the secret, again, for conﬁrmation.

• Protocol: Protocol used in the user authentication. This protocol is ﬁxed to CHAP.

4. Click OK.Thespeciﬁed host user information appears in blue in the Authentication Information

(Host) li

st.

5. Click Apply.Aconﬁrmation message appears.

6. Click OK. Settings are applied to the array.

NOTE:

You shou

ld register user information for all hosts to be connected to a host group that performs

authent

ication of hosts. To allow a speciﬁchosttoconnecttosuchahostgroupwithoutauthentication,

conﬁgu

re the host group and the host as follows.

• On the host:

It does not matter if you conﬁgure the host for authentication by ports with CHAP.

Changing a host's user information (Fibre Channel environments)

You can change the host's registered user name or secret, and switch authentication settings between

Enable and Disable after registration.

NOTE:

You cannot change the WWN when you change user information.

1. Start LUN Manager, and display the Authentication pane (Figure 31).

11 6

LUN Manager operations

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 219 220

Brak uwag

Hp StorageWorks XP10000 Disk Array Instrukcja Użytkownika Strona 116