HP FB910 Podręcznik Użytkownika

1 HP Scitex FB910 Printer Preparing the printer for transport

10 Figure 12 User-end cable connections to chassis 2. Remove the ink boxes (cartridges) and ink profilers the printer prior to transport. Be

11 6. Disconnect the foot switch. Figure 15 Foot switch connection 7. Disconnect the printer from the facility pneumatic air supply or comp

12 9. Use the 13mm wrenches or sockets to attach the wheels at the four corners of the printer. Figure 18 Wheel attachment 10. Rotate the l

2 © 2012 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties f

3 1 Overview There are three main areas that need to be attended to before moving the printer: 1. Preparation of the printheads 2. Preparatio

4 2 Printhead preparation This process empties all the ink from the printheads and consumes a quantity of printhead flush solution. Be prepared

5 2.2 Procedure 1. From the printer’s control panel, select “Tools | Maintenance | Printheads Procedures | Empty Heads (Fill with Air)”. Follo

6 7. Locate the right-slave printhead for each color and remove the air U-tube as shown in Figure 7. Figure 7 Removal of air U-tube from righ

7 3 Carriage preparation The carriage must be isolated from the rail to prevent damage to both the rail and the carriage wheels. When the print

8 9. Place an absorbent pad on top of the Saran Wrap. The pad and the wrap are to prevent any seeping liquids from getting on the belt or into

9 4 Chassis preparation 4.1 Required tools and materials  Forklift with 45" long (about 144 cm) forks that span up to 42" (about 10