HP Remote Graphics Software (RGS) Instrukcja Użytkownika Pobierz pdf (Strona 75)

unless the network has been carefully designed for maximum throughput, the network interfaces and

switches might auto-negotiate to a sub-optimal speed.

If the network interface and switches are congured to auto-negotiate properly, you can leave the settings to

auto-negotiate. If you want to force the network to operate at a particular speed, the settings in the network

interface and switches can be hard-coded. You must be careful with these settings, however. If the network

interface and switch settings don’t complement each other, the network will have poor performance.

To congure a network interface to force a particular network speed on Windows:

1. In Control Panel, select Device Manager.

2. Expand Network adapters.

3. Right-click the network adapter you want to congure, and then select Properties.

4. Click the Advanced tab.

5. In the list of properties, locate the property that controls the speed and duplex setting. The name can

vary, but it is usually something like Speed & Duplex or Link Speed & Duplex.

6. From the Value drop-down list, select the fastest speed your network can support, and be sure to select

the Full Duplex version of that speed.

To congure a network interface to force a particular network speed on Linux:

▲

As root, use a command like in the following example. This example sets network interface 0 as a 100

Mb/sec connection running full duplex mode:

$ /usr/local/sbin/ethtool -s eth0 speed 100 duplex full autoneg off

If you are not satised with your network performance, look at the log les on your network switch (if the

receiver is connected to one). A signicant number of errors on the switch port may indicate that the

computer or network is not congured correctly. Work with your IT organization to optimize your computer

and network conguration.

Troubleshooting tips

Troubleshooting failed connection attempts

This section describes the most common issues that cause RGS connection attempts to fail.

Failed connection attempt troubleshooting checklist (receiver)

Use the following checklist to troubleshoot failed connection attempts from the receiver side:

1. Verify that you are inputting the correct hostname or IP address for the sender.

If you changed the port that RGS Sender listens on from its default of 42966, you must specify the port

number along with the hostname or IP address like in the following examples:

MyHostName:12345

192.168.0.10:12345

2. Verify that the receiver is on the same network as the sender.

3. Verify that the receiver can ping the sender.

4. If the receiver is behind a rewall, verify that the rewall supports network address translation (NAT).

Troubleshooting tips 65

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 96 97

Brak uwag

HP Remote Graphics Software (RGS) Instrukcja Użytkownika Strona 75