Hp Netserver L Server series Instrukcja Użytkownika Pobierz pdf (Strona 11)

Chapter 1 Installation Overview

5. If you are installing any accessory boards or additional mass storage

devices (other than hot swap disk drive modules), also remove the side

cover farthest from the system board:

a. Grasp the two tabs at the top of the side cover.

b. Pull upward and outward to lift the side cover off.

CAUTION Handle the side cover only by its top and bottom edges to

avoid damaging the EMI spring Angers inside its side edges.

Install Additional Memory

CAUTION Use only DIMMs acquired from HP. Refer to the following for

a list of qualified DIMMs:

• Technical Reference Label inside the HP NetServer top

cover

• HP Order Assistant on the HP Web Site at

http://www.hp.com/go/netserver

• Information Assistant on the HP Navigator CD-ROM

• HP Customer Service

When handling DIMMs, observe antistatic precautions to

avoid damage.

Remove the System Board

If you are adding additional memory, remove the system board ^st. Use the

retaining latches to start lining the system board. Grasp the metal bracket at the

top of the system board, and li^ the system board straight up and out of the HP

NetServer, as shown in Figure 1-2

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 111 112

Brak uwag

Hp Netserver L Server series Instrukcja Użytkownika Strona 11