Hp Netserver L Server series Instrukcja Użytkownika Pobierz pdf (Strona 48)

Chapter 6 Troubleshooting

Error Message Is Displayed

There are two kinds of error messages that may prevent the HP NetServer from

booting. These are:

• Highlighted error messages (white text on gray background). Press ENTER

to see a definition of the message and what action to take to remedy the

problem.

• Error messages displayed in normal video.

If an HP NetServer configuration error is reported during the startup routine, clear

the system configuration memory and reconfigure as described under “Clearing the

System Configuration,” and restart the HP NetServer.

Power-On System Hardware Test Error Messages

If an error occurs during the power-on system hardware test (POST) when the HP

NetServer starts, press ENTER to view system error to display details of the error.

Follow the instructions on the screen. Correct the error before proceeding, even if

the HP NetServer appears to start successfully.

If the HP NetServer starts, but the power-on system hardware test still reports an

error message, clear the system configuration memory, as described in "Clearing

the System Configuration."

The following table describes common errors and the corrective action you may

take to remedy the problem:

Message Corrective Action

Operating system

not found

Check whether the drive from which you are booting has

the power and SCSI flat cables connected. Verify that the

SCSI cable is securely plugged into the SCSI controller

board. Narrow (50-pin) SCSI devices require the wide-to-

narrow SCSI adapter with the white body on the SCSI

cable.

Check that the boot device is enabled in the Hardware

Security submenu under the Security menu of the Setup

utility. If possible, check the drive by moving it to another

system. If the problem persists, contact your HP support

organization.

Verify that the boot device has an operating system

installed.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 111 112

Brak uwag

Hp Netserver L Server series Instrukcja Użytkownika Strona 48