Hp ProLiant DL320e Gen8 v2-Server Instrukcja Użytkownika Pobierz pdf (Strona 48)

Hardware options installation 48

Align the notch on the bottom edge of the memory module with the keyed surface of the DIMM slot, and

then fully press the memory module into the slot until the latches snap back into place.

8. Install the air baffle (on page 19).

9. Install the access panel (on page 17).

10. Do one of the following:

o Slide the server into the rack.

o Install the server into the rack ("Installing the server into the rack" on page 26).

11. Connect the peripheral devices to the server.

12. Connect the power cord to the server.

13. Connect the power cord to the power source.

14. Power up the server (on page 14).

15. After installing the DIMMs, to configure memory protection mode, use RBSU ("HP ROM-Based Setup

Utility" on page 69).

Expansion board options

The server has both full-height and low-profile expansion slots for controller option installation ("PCIe riser

board slot definitions" on page 8). Controller options with internal cable connections should be installed in

the full-height riser board slot 1.

For more information about product features, specifications, options, configurations, and compatibility, see

the product QuickSpecs on the HP Product Bulletin website (http://www.hp.com/go/productbulletin).

CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless

all expansion slots have either an expansion slot cover or an expansion board installed.

To install the component:

1. Power down the server (on page 14).

2. Remove the power from the server:

a. Disconnect the power cord from the power source.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 99 100

Brak uwag

Hp ProLiant DL320e Gen8 v2-Server Instrukcja Użytkownika Strona 48