Hp LC 2000 Instrukcja Użytkownika Pobierz pdf (Strona 163)

Chapter 13 Alternative Rack Mounting

155

The mounting tabs in the slides should be in position to fit into the

openings in chassis. See Figures 13-6 and 13-7.

8. Lower the NetServer onto the slide members.

The NetServer’s handles will temporarily support the NetServer on the

slides.

9. Adjust the NetServer’s position on the slides to line up the 6 mounting

holes on the side (3 each) of the chassis with the screw holes in the slide

members.

10. Insert the flathead screws into the slides’ holes at the rear and the panheads

screws in the other four places to secure the chassis to the slides.

11. Use a Torx T-15 driver to remove the screws holding the handles to the

NetServer. See Figure 13-8.

12. Take the handles off the NetServer and store the handles and screws in a

convenient place.

The handles can be re-attached whenever you remove the NetServer from

the rack. If moving the NetServer elsewhere, always package it with the

handles attached.

Figure 13-8. Removing the Mounting Handles

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 193 194

Brak uwag

Hp LC 2000 Instrukcja Użytkownika Strona 163