Hp Z210 Convertible Minitower-Workstation Instrukcja Użytkownika Pobierz pdf (Strona 55)

4. Push the sled containing the HDD into the selected bay until it snaps into place (1) as shown in the

following figure.

Figure 9-3 Installing the HDD drive

5. Attach a power cable (2), and a data cable (3), to the hard disk drive.

CAUTION: To avoid crushing or pinching the data cable when you replace the access panel,

use the HP-supplied data cable with right-angle connectors.

NOTE: Connect data cables to lower-numbered drive connectors first on the system board. To

identify hard disk drive ports, refer to the workstation service label on the side access panel.

NOTE: Blue SATA ports (numbered zero and one) support SATA Gen 3 (6 Gbit/sec).

6. Replace all components that were removed in preparation for component installation.

Installing an HDD in an HP Z210 SFF Workstation

To install an HDD:

1. Follow the procedures described in

Preparing for component installation on page 34 to prepare

the workstation for component installation.

ENWW

Installing a hard disk drive

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 67 68

Brak uwag

Hp Z210 Convertible Minitower-Workstation Instrukcja Użytkownika Strona 55