HP 2103R-CSDI Instrukcja Użytkownika Pobierz pdf (Strona 44)

3-4

Configuring the

Carrier in a

Managed ONline

Hub

This section describes how to use network management commands to

configure ONline carriers installed in an ONline System Concentrator. This

section contains the following topics:

■

Selecting a Network

■

Saving the Configuration

When you install the carrier in a hub with a management module installed,

the network defaults to isolated mode (Isolate_1). You must assign a

network as described below.

Selecting a Network

The engine connects to the backplane through a carrier module port on the

ONline carrier. You can assign the carrier module port to:

■

One of three Ethernet backplane networks

■

Isolated mode

For details on backplane networks, refer to the

ONline System Concentrator

Installation and Operation Guide

(Document Number 17-00417).

To assign the carrier module ports to a network using the network

management software, use the following command:

ONline> set port

slot.port

network {ethernet_1 ... _3}

{isolated_1}

For example, the following command sets port 1 in the ONline carrier

installed in slot 3 to the Ethernet 2 backplane network:

ONline> set port 3.1 network ethernet_2

Port 03.01 network id set to ETHERNET_2

Saving the

Configuration

To save configuration changes, use the SAVE command. For example, the

following command saves all configuration changes:

ONline> save all

If you do not save module settings, you may lose configuration data.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 91 92

Brak uwag

HP 2103R-CSDI Instrukcja Użytkownika Strona 44