HP B3000 Przewodnik Instalacji Strona 13

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 28
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 12
[Enter your Document Title]
[Document Restriction Notice]
Create a small partition [A minimum of 50 megabytes (MB) to be used as a quorum disk.
We recommend a quorum disk have at least 1GB of free space.]
Dedicate a separate disk resource for a quorum disk. As the failure of the quorum disk
would cause the entire cluster to fail, it is strongly recommended that the disk resource be
a RAID 1 configuration.
During the Cluster service installation, a drive letter must be provided for the
quorum disk. It is recommended to use the drive letter Q for the quorum disk.
Configuring Shared Disks
Use Disk Management to configure the quorum and shared disk resources.
Verify that all shared disks are formatted as NTFS and are designated as Basic.
Verifying Disk Access and Functionality
Write a file to each shared disk resource to verify functionality.
At this time, shut down the first node, power on the second node and repeat the
Verifying Disk Access and Functionality step above. When it has been verified
that both nodes can read and write from the disks, shut down the second node
and power on the first, and then continue with this guide.
Install Cluster Service Software and Configuring the First Node
Note: During installation of Cluster service on the first node, the second node
must be shut down. All shared storage devices should be powered up.
In the first phase of installation, all initial cluster configuration information
must be supplied so that the cluster can be created. This is accomplished using
the Cluster Service Configuration Wizard.
1. Click Start, click Settings, and click Control Panel.
2. Double-click Add/Remove Programs.
3. Double-click Add/Remove Windows Components.
4. Select Cluster Service. Click Next.
5. When prompted for files on the Windows Powered OS CD or the Windows 2000 SP3
cd, browse to the directory C:\Compaq\Windows Components\i386.
6. The window shown in Figure 7 below appears. Click I Understand to accept the
condition that the Cluster service is supported on hardware from the Hardware
compatibility List only.
12
Przeglądanie stron 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Komentarze do niniejszej Instrukcji

Brak uwag