HP EML Base Library Przewodnik Szybki Start

HP StorageWorks EnterpriseModular Library E-Series 71eGetting Started© Copyright 2006–2010 Hewlett-Packard Development Company,L.P.4th edition: April

If the Interface Manager card does not have access to an IPv4 DHCPnetwork during initial power up, the Interface Manager must beconfigured manually. T

The library ships with a null password. Passwords must be set to ex-actly eight characters consisting of the numbers 0 through 9 and theperiod charact

2. Use the template shipped with the library to mark the front and backof the rack with the locations of the mounting hardware.If your library contain

2. At the rear of the library, guide the notches on the bottom cornersof the 8U base module onto the mounting brackets. Slide the 8Ubase module comple

2. Lift the 4U base module into position in the rack. The top of the 4Ubase module has rails on each side that fit into the L-flange of themodule abov

5 Plug in the OCP cables1. Remove the two T-10 Torx screws from the bottom-left and top-rightcorners of the black protective cover that is on the back

2. Pull the ribbon cable out of the 8U base module. Plug the ribboncable into the 4U base module.3. Install the cover from the 4U base module onto the

1. Attach the brackets to the switch.2. Connect the power cable to the power socket on the back of theswitch.3. At the rear of the library, install tw

2. Attach the cable clamps to the right rear rack at the positions 37T,26T, and 15T. Use these cable clamps to route the tape driveEthernet cables.13

• Plug each power supply into a power strip (power cable included).Plug each power supply into a different power strip. You cannot plugthe power suppl