HP VMA-series Memory Arrays Instrukcja Użytkownika Pobierz pdf (Strona 72)

72 AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide

A message confirms that the VMA Array was successfully initialized.

Viewing Containers

Once you have initialized the VMA Array, you can see the container created using

the

show containers command.

1. Log on as an administrator into the HP VMA SAN Gateway attached to Port 1

of the VMA Array.

Before a block media device can be used for block storage, it must be enabled.

Use the

media block id <id> enable command to enable the device.

2. Enter into Config mode using the configure terminal command.

3. Run the media block id <id> enable command to enable all block

containers.

The

block parameter ensures that you enable vSHARE devices and not

vCACHE devices. The

all parameter ensures that every block container is

enabled.

4. To verify the containers were created, run the show containers command

to view information about the containers.

media init completed successfully

SM076 [NJ-Lab-vSHARE00: standby] (config) #

# configure terminal

(config) #

(config) # media <tab>

(config) # media block id all enable

> enable

# show containers

Container LUNs Total Free Ports HostnameA HostnameB Status

---------------------------------------------------------------------------

C-1 0 199G 199G A,B <hostname> <hostname> Single

C-2 150 199G 50176M A,B <hostname> <hostname> Single

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 277 278

Pasquale 21 Mar 2024 | 21:21:23

5 Lessons You Can Learn From Pornstar UK pornstar uk

Stanley 29 Mar 2024 | 00:42:15

7 Simple Secrets To Totally Moving Your Xxx Of Pornstar xxx of pornstar

HP VMA-series Memory Arrays Instrukcja Użytkownika Strona 72