HP VMA-series Memory Arrays Instrukcja Użytkownika Pobierz pdf (Strona 18)

h. The direct connect Ethernet link between the Laptop and the VMA Array should now be

configured and able to establish communication. To verify the link is configured, launch

the Command Prompt utility; and use the ping command to test the connection.

NOTE: For additional Windows XP COM port Configuration information, see Additional

Windows XP COM port configuration information“Windows XP COM port configuration

information” (page 26).

Transferring the new VMA firmware file to the VMA Array

Now that you have established both the serial and Ethernet connections between the Laptop and

VMA Array, the next step is to transfer the VMA firmware file to the Array using an scp utility.

WARNING! Do not attempt to backdate or downgrade to an older version of firmware on the

VMA Array. Backdating or downgrading of VMA Array firmware is not supported and can cause

the array to be in an irreparable state. Update only with firmware which is of the same or newer

version for the VMA32xx series Array. In cases when you need to change the connectivity mode

of the VMA Array from a single PCIe connection (single x8) to a dual PCIe connection (dual x4),

upgrading with the same or newer version of firmware but with a different connectivity mode,

single x8 or dual x4, is supported.

Also be sure to use the appropriate firmware which is compatible with the type of VMA Memory

Modules used in the array. The VMA32xx Arrays use SLC NAND Flash Memory Modules; and

you must only use firmware specific for the SLC Memory Modules. To distinguish the specific

firmware, the firmware file name will have slc or mlc as part of the file name.

NOTE: Only use the SLC (NOT MLC) version of firmware on VMA32xx Arrays.

18 Updating the HP VMA3205 and VMA3210 Array Firmware

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 28 29

Brak uwag

HP VMA-series Memory Arrays Instrukcja Użytkownika Strona 18