HP SuperStack 3 Load Balancer Appliance Instrukcja Użytkownika Pobierz pdf (Strona 18)

18 CHAPTER 2: INSTALLING THE SERVER LOAD BALANCER

Package Contents Your shipping container should contain the following items:

■ Server Load Balancer (3C11620)

or Server Load Balancer Plus (3C11621)

■ User Guide (this guide)

■ Power Cord

■ 2 x mounting brackets

■ 6 x screws

■ 4 x rubber feet

Choosing a Suitable

Site

The Server Load Balancer is suited for use where it can be mounted in a

standard 19-inch equipment rack, or free-standing. A rack-mounting kit,

containing two mounting brackets and six screws is supplied with the

unit.

CAUTION: Ensure that the ventilation holes are not obstructed.

When deciding where to position the Server Load Balancer, ensure that:

■ Cabling is located away from sources of electrical noise such as radios,

transmitters and broadband amplifiers.

■ Cabling is located away from power lines and fluorescent lighting

fixtures

■ The Server Load Balancer is accessible and cables can be connected

easily.

■ Water or moisture cannot enter the case of the Server Load Balancer.

■ Air-flow is not restricted around the Server Load Balancer or through

the vents in the side of the Server Load Balancer. 3Com recommends

that you provide a minimum of 25 mm (1 in.) clearance.

■ The air is as free from dust as possible.

■ No more than four Server Load Balancer units are placed on top of

one another, if the units are free-standing.

■ Temperature operating limits are not exceeded. It is recommended

that the unit is installed in a clean, air conditioned environment.

■ Ensure there is adequate clearance at the front of the unit to ensure

that the fibers are not damaged as they have a restricted bend radius.

slb_gsg.bk Page 18 Thursday, May 31, 2001 8:57 AM

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 98 99

Brak uwag

HP SuperStack 3 Load Balancer Appliance Instrukcja Użytkownika Strona 18