HP Z200 Dokumentacja Pobierz pdf (Strona 86)

Side access panel sensor (optional)

The side access panel sensor is a remote solenoid that detects when the side access panel is opened.

This section describes how to remove and install the sensor.

Removing the side access panel sensor

To remove the side access panel sensor:

1. Disconnect power from the computer (see

Predisassembly procedures on page 70).

2. Remove the side access panel (see

Removing the side access panel on page 73).

3. Disconnect the sensor cable from the in-line chassis cable as shown below (1).

Figure 5-4 Removing the side access panel sensor

4. Slide the sensor back in its slot, push the sensor down, and then remove it from the chassis (2).

Installing the side access panel sensor

To replace the side access panel sensor, reverse the previous steps.

74 Chapter 5 Replacing components ENWW

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 191 192

Brak uwag

HP Z200 Dokumentacja Strona 86