HP 200 Unified Threat Management (UTM) Appliance Series Przewodnik Szybki Start Pobierz pdf (Strona 70)

Accessing the device through SNMP

NOTE:

ccessin

the device throu

h SNMP is not supported in FIPS mode.

You can run SNMP on an NMS to access the device MIB and perform GET and SET operations to

manage and monitor the device. The device supports SNMPv1, SNMPv2c, and SNMPv3, and can work

with various network management software products, including IMC. For more information about SNMP,

see System Management and Maintenance Configuration Guide.

By default, SNMP access is disabled. To enable SNMP access, log in to the device through any other

method and configure SNMP login.

Configuring SNMP access

Connect the PC (the NMS) and the device to the network, making sure they can reach each other, as

shown in Figure 53. T

his document describes only the basic SNMP configuration procedures on the

device.

Figure 53 Network diagram

IMPORTANT:

To make SNMP operate correctly, make sure the SNMP settin

s (includin

the SNMP version) on the NMS

are consistent with those on the firewall.

Prerequisites

• Assign an IP address to a Layer 3 interface on the firewall. By default, only interface

GigabitEthernet 0/0 is assigned an IP address (192.168.0.1/24).

• Configure routes to make sure the NMS and the Layer 3 interface can reach each other.

Configuring SNMPv3 access

Ste

Command

Remarks

1. Enter system view.

system-view N/A

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 149 150

Brak uwag

HP 200 Unified Threat Management (UTM) Appliance Series Przewodnik Szybki Start Strona 70