HP PCIe Workload Accelerators for ProLiant Servers Instrukcja Instalacji Pobierz pdf (Strona 4)

1 Introduction

This document describes how to install an HP PCIe Workload Accelerator half-height, half-length

(HHHL) PCIe NAND Flash SSD into a host system and complete the required steps to get the drive

into a functional state. Additional documentation is referenced as needed.

This document provides:

• An overview of the HP PCIe Workload Accelerator HHHL form factor SSD

• A description of the software and hardware provided by HP

• System recommendations

• Device installation

• Support pack installation

• Installation verification steps

• Troubleshooting steps

• A description of LED codes

HP PCIe Workload Accelerator Overview

The HP PCIe Workload Accelerator solid state drive (SSD) is a PCI Express® (PCIe) Gen

2-compatible drive that conforms to the PCIe Card Electromechanical (CEM) specification version

2.0, section 6.1 (low profile add-in card size). This is also called the half-height, half-length (HHHL)

form factor. The HP PCIe Workload Accelerator HHHL drive is available in two capacities: 350GB

and 700GB. Both options have the same HHHL form factor and support a x8 link width and PCIe

Gen 2-compatible motherboard slot.

The HP PCIe Workload Accelerator HHHL card is shown in the following figures:

4 Introduction

1 2 3 4 5 6 7 8 9 ... 20 21

Brak uwag

HP PCIe Workload Accelerators for ProLiant Servers Instrukcja Instalacji Strona 4