Hp 3PAR Operating System Software Instrukcja Użytkownika Pobierz pdf (Strona 69)

2. Define a target on the primary storage system (for example, System1).

• For RCIP:

# creatercopytarget <target_name> IP <N:S:P>:<link_IP_addr>

<N:S:P>:<link_IP_addr>

◦ <target_name> - Name of the target system (for example, System2)

◦ IP - Defines link as an IP link

◦ <N:S:P> - Location on the current system (System1) that contains the IP connections

to the target system, expressed as node:slot:port

◦ <link_IP_addr> - Link IP address for the corresponding port on the target system

(for example,172.16.1.12 or 172.16.2.12).

• For RCFC:

# creatercopytarget <target_name> FC <node_WWN> <N:S:P:WWN> <N:S:P:WWN>

◦ <target_name> - Name of the target system (for example, System2)

◦ FC - Defines link as an FC link

◦ <node_WWN> - WWN of the node on the target system

◦ <N:S:P:WWN> - Location on the current system (System1) of the FC adaptor port,

expressed as node:slot:port, and the WWN of the corresponding node on the target

system

NOTE: On each node, you can only configure one link per target definition.

SolutionProblem

Before admitting a link to a target definition, Remote Copy checks

its throughput and latency. If link performance is below standard,

Remote Copy does not admit the link. For more information, see:

• “Checking Link Throughput and Latency”

(page 36)

• The eventlog

Setting Up the Backup System

When you set up the links on the backup storage system, you create the links in the opposite

direction.

1. Start Remote Copy on the backup storage system (for example, System2).

# startrcopy

Setting Up the Backup System 69

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 291 292

Brak uwag

Hp 3PAR Operating System Software Instrukcja Użytkownika Strona 69