Hp XP Command View Advanced Edition Software Instrukcja Użytkownika Pobierz pdf (Strona 42)

Procedure

1. Execute the following KTSETENV command.

START KTSETENV,PARM='parameter=parameter-value'

2. Use the KTDSPENV command as follows to confirm that the environment variables have been

specified correctly:

START KTDSPENV,PARM='DETAIL'

Example of executing the KTSETENV command

• When setting the name of the license information dataset to HPQ1.HPQ2.CCENTRAL.LICENSE

START KTSETENV,PARM='YKLCNSE=HPQ1'

START KTSETENV,PARM='YKLCNS2=HPQ2'

• When specifying whether to use the system logger service to collect event logs

START KTSETENV,PARM='LOGPUT=LOGR' (if using the system logger service)

START KTSETENV,PARM='LOGPUT=SAM' (if not using the system logger service)

• When specifying whether to output CLI command execution logs to SYSLOG

START KTSETENV,PARM='SYSLOG=YES' (if outputting to SYSLOG)

START KTSETENV,PARM='SYSLOG=NO' (if not outputting to SYSLOG)

TIP:

This setting is invalidated if an IPL is performed again. Perform either of the following in caseyou need

to perform an IPL again the next time:

• Add the KTSETENV command to the COMMNDxx parmlib member to automatically set the envir-

onment variables when an IPL is performed again.

• For the IEASYMxx parmlib member, specify the system symbols so that the statically-registered

settings will be used the next time an IPL is performed.

TIP:

Use either the environment variables or the system symbols to specify both prefix-1 and prefix-2.

If you use the environment variable to specify prefix-1 and use the system symbol to specify

prefix-2, the process of determining the prefixes will be complicated.

Installation and setup42

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 309 310

Brak uwag

Hp XP Command View Advanced Edition Software Instrukcja Użytkownika Strona 42