HP E1368A Instrukcja Użytkownika Strona 27

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 86
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 26
After selecting the coaxial switch or attenuator, install as follows:
1. Position the coaxial switch or attenuator behind the panel cut-out.
Use two M3.0 x 8mm (P/N 0515-0372) metric screws to secure the
rear panel. Use two 4-40 x .25 inch screws (P/N 2200-0521) to
secure the attenuator to the rear panel.
2. Route the ribbon cable from the Microwave Switch or Attenuator to
the 14-pin connector on the PC board.
3. Install the correct filler panel on the switch so that minimal air can
flow through the slot.
Figure 2-7. Microwave Switch/Attenuator Installation
Chapter 2 Configuring the HP E1368A/69A/70A Modules 27
Przeglądanie stron 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 85 86

Komentarze do niniejszej Instrukcji

Brak uwag