HP 450 Dokumentacja Pobierz pdf (Strona 93)

5. To remove the wireless antenna cables and transceivers:

a. Position the display assembly with the bottom edge toward you.

b. Release the wireless antenna transceivers (1) from the display enclosure. (The wireless

antenna transceivers are attached to the display enclosure with double-sided tape.)

NOTE: Some models may only have one antenna transceiver.

c. Release the wireless antenna cables from the clips (2) built into the display enclosure.

d. Remove the wireless antenna cables and transceivers (3).

NOTE: Models may have either one or two antennas installed.

6. If replacing the display enclosure, be sure that the other subcomponents (including the webcam/

microphone module, the antenna receivers, and all associated cables and hardware) are

transferred to the new enclosure.

Reverse this procedure to reassemble and install the display assembly.

Component replacement procedures 85

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 141 142

Brak uwag

HP 450 Dokumentacja Strona 93