HP ProDesk 600 G3 Base Model Small Form Factor PC Instrukcja Użytkownika Pobierz pdf (Strona 43)

●

The primary Serial ATA (SATA) hard drive must be connected to the dark blue primary SATA connector on

the system board labeled SATA0.

●

Connect an optical drive to the light blue SATA connector on the system board labeled SATA1.

IMPORTANT: To prevent loss of work and damage to the computer or drive:

If you are inserting or removing a drive, shut down the operating system properly, turn o the computer, and

unplug the power cord. Do not remove a drive while the computer is on or in standby mode.

Before handling a drive, be sure that you are discharged of static electricity. While handling a drive, avoid

touching the connector.

Handle a drive carefully; do not drop it.

Do not use excessive force when inserting a drive.

Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic elds such as

monitors or speakers.

If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and label the

package “Fragile: Handle With Care.”

Drive positions

1 3.5-inch hard drive bay

2 9.5 mm slim optical drive bay

NOTE: The drive conguration on your computer may be dierent than the drive

conguration shown above.

Drives 35

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 149 150

Brak uwag

HP ProDesk 600 G3 Base Model Small Form Factor PC Instrukcja Użytkownika Strona 43