HP ProDesk 600 G3 Base Model Small Form Factor PC Instrukcja Użytkownika Pobierz pdf (Strona 50)

6. Connect the data cable (1) and power cable (2) to the rear of the hard drive.

NOTE: The data cable for the primary hard drive must be connected to the dark blue connector on the

system board labeled SATA0 to avoid any hard drive performance problems.

Removing and installing an M.2 SSD storage card

NOTE: The computer supports 2230 and 2280 M.2 SSD cards.

1. Prepare the computer for disassembly (Preparation for disassembly on page 20).

2. Remove the access panel (Access panel on page 21).

3. Remove the front bezel (Front bezel on page 22).

4. Remove the drive cage (Drive cage on page 25).

5. To remove an M.2 SSD card, remove the screw that secures the card (1), lift the end of the card up (2),

and then slide the card out of the system board connector (3).

42 Chapter 4 Removal and replacement procedures: Small Form Factor

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 149 150

Brak uwag

HP ProDesk 600 G3 Base Model Small Form Factor PC Instrukcja Użytkownika Strona 50