HP 10-Base-T Instrukcja Instalacji Pobierz pdf (Strona 15)

1-3

Installing the Hub

Installing Your Hub

Installing the Hub

external transceiver). Because of these widths, clearance in front of your hub

may be a factor in the placement of the device or stack that contains

protruding transceiver connectors, for example, a BNC connectors.

Inspect your installation site and identify whether enough room will be

available for the installed transceiver to be connected. Then see the guide that

shipped with your external transceiver for installation instructions. For HP

external transceivers, see the HP Recessed Transceivers Installation Guide

(p/n 5962-0066) for specific instructions.

Your transceiver modules can be one of the following:

■ HP J2606A Fiber-Optic Transceiver Module

■ HP J2607A Twisted-Pair Transceiver Module

■ HP J2608A ThinLAN Transceiver Module

■ HP J2609A AUI Port Module

3. Verify the hub operates correctly

Before mounting the hub, connect it to a power source and verify that the hub

will operate correctly.

1. Plug the power cord into the hub’s power cord receptacle and into an AC

power source.

Notes The hub does not have a power switch; it is powered on when the power cord

is plugged in.

Connect female end of included power cord

into male receptacle here and male end of

power cord to an alternating current power

source.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 53 54

Brak uwag

HP 10-Base-T Instrukcja Instalacji Strona 15