HP 100BaseT Podręcznik Użytkownika Pobierz pdf (Strona 63)

HP 100Base-T Hubs Installation and Reference Guide

4-4 Configuring the System

Configuring the Remote Site

At the remote site, connect the PC’s COM port (COM 1~4) to

the modem’s serial port. Set terminal emulation type to

VT-100, specify the port used by your PC (i.e., COM 1~4), and

then set communications to 8 data bits, 1 stop bit, no parity, and

9600 bps. Also be sure you set the flow control to “none.”

Remote Configuration Methods

Remote Out of Band - If you establish a remote connection as

described in the previous section, you can use the on-board

configuration functions on the Hub-12TXM via the VT-100

console interface. See the section on

8VLQJWKH97&RQVROH

,QWHUIDFH

later in this chapter for more information. However,

note that the Hub-12TXM on-board configuration functions

only provide access to the hub’s private MIB.

Before accessing a hub

using a SLIP link, be sure you

have already set the hub’s

serial IP address via the

VT-100 console interface.

Remote In-Band - You can also make a remote network

connection to the Hub-12TXM via the Console Port using the

SLIP protocol over TCP/IP. This connection can only be made

with the VT-100 console interface, and not HP AdvanceStack

Assistant. Note that the system functions as a router when you

use IP protocol over a SLIP link to the Console Port, providing

direct access to all attached network resources.

To establish a SLIP link to the Console Port, be sure you first

set the hub’s serial IP via the VT-100 console interface. Note

that the hub’s serial IP address and it’s IP address must be

different, but both should be on the same subnet. When

accessing the hub, the PC at the remote site must also be

configured with the same serial IP address as the hub.

Note: The winsocket used by both Windows 95 and Windows NT

supports the SLIP protocol. To configure, start the Windows

Accessories Dial-Up Networking and select SLIP as the server type.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 156 157

Brak uwag

HP 100BaseT Podręcznik Użytkownika Strona 63