HP 100BaseT Podręcznik Użytkownika Pobierz pdf (Strona 65)

HP 100Base-T Hubs Installation and Reference Guide

4-6 Configuring the System

From a Telnet connection -

Telnet into the target hub using its assigned IP address.

From a remote modem connection -

Use a VT-100 terminal emulation package to connect to the

Com port that is attached to the modem. Configure the

connection for 9600 baud, 8 data bits, no parity bits, and 1

stop bit. Then dial in to the hub.

If the screen is blank, press the Enter key several times until

the login screen appears. If diagnostic messages indicate a

failure, refer to

7URXEOHVKRRWLQJ in Appendix A. Once the

connection has been properly established, the login screen for

the on-board configuration program should appear.

2. The login procedure for the Hub-12TX/Hub-24TX VT-100

console interface requires no password or user name, although

the VT-100 Console Interface does display a password

prompt. Simply press Enter to enter the VT-100 Console

Interface menu system. Access privileges are Read/Write,

and the default password is blank (i.e., no password has been

pre-configured). You can set a password if you want by using

the Change Password option in the Main Menu.

When logging into the Hub-12TXM, there are two fixed user

types, Admin and Guest. The Administrator account has

read/write access, and the Guest has read-only access. You

must provide both a user name and password to log in,

however for initial configurations, both the user name and

password is blank. Just press the Enter key. Administrator is

the highest privilege level in the Hub-12TXM VT-100 console

interface. The administrator should define a password, record

it and put it in a safe place. If you have not already done so,

select User Passwords under the Console Security menu in the

VT-100 console interface and enter a password.

The configuration parameters you can access after logging

into the system are described in the following section.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 156 157

Brak uwag

HP 100BaseT Podręcznik Użytkownika Strona 65