HP 8800 Router Series Instrukcja Instalacji Pobierz pdf (Strona 63)

Figure 41 CF card slot

(1) CF card cover (2) CF card eject button

(3) CF card (4) CF card LED

The CF card is installed on the MPU of the router. If the CF card memory is insufficient or the CF card

is damaged, follow these steps to replace the card. Before inserting the CF card, make sure the eject

button is all the way into the slot and does not project from the panel.

1. Examine the CF card LED status.

{ If the LED is on, you cannot remove the CF card. You must unmount the CF card using the CLI

and wait until the CF card LED is off before removing the CF card.

<Sysname> umount cfa0:

{ If the LED is flashing, the CF card is reading and writing data. In this case, you cannot remove

the CF card. Wait until the CF card LED stops flashing before removing it.

{ If the LED is off, the CF card has been unmounted and you can remove it.

NOTE:

fter you execute the umount cf command, if you want to continue to use the CF card, execute the

mount cf command in user view to load the CF card again. For more information about the umount

and mount commands, see

HP A8800 Routers Fundamentals Command Reference

2. Use a Phillips screwdriver to loosen the screw on the right side of the CF card cover, and then

pull the CF card cover outward.

3. Press the eject button of the CF card reader. The reader ejects the card partway out of the slot.

Remove the CF card from the reader and put it in an antistatic bag or its original shipping

materials.

4. Push the new CF card all the way into the CF card slot. The eject button will project out.

5. Push the CF card cover inward.

6. Use a Phillips screwdriver to fasten the screw on the right side of the CF card cover.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 120 121

Brak uwag

HP 8800 Router Series Instrukcja Instalacji Strona 63