HP 8800 Router Series Instrukcja Instalacji Pobierz pdf (Strona 8)

Rack-mounting requirements

Before rack-mounting a router, make sure the rack meets the following requirements:

• HP recommends that the router is mounted in an open rack. If you mount a router in a closed

rack, make sure there is a good heat dissipation system.

• The rack is steady enough to support the router and accessories.

• The router fits the rack size. Leave some space beside the left and right panels of the router for

chassis heat dissipation.

Installation tools

Accessories supplied by the router

Item Quantit

Pur

ose

Console cable 1

Connecting the console port and the configuration

terminal for router login

Grounding cable 1 Grounding the router

Mounting brackets 1 pair Fastening the router to the rack

Cable management

brackets

1 pair Cable management

M4*8 screw 1 set

• Fastening the mounting brackets to the router

• Fastening the cable management brackets to the

router

M6*12 screw 1 set

Fastening the router to the rack

M6 cage nut 1 set

ST2.9*9.5 self-

tapping screw

1 set

Fastening the cable management brackets to the

mounting brackets (excluding the A8808)

Impedance carrier

1 (supplied with the

A8808 only)

Installed at the rear of the router to block air from

entering the chassis

ESD-preventive wrist

strap

1 ESD prevention

NOTE:

The number of screws and nuts supplied with the router may vary.

User-supplied tools and equipment

• Cross-head screwdriver P1 – 100 mm, P2 – 150 mm, and P3 – 250 mm

• Flat-blade screwdriver P4 – 75 mm

• Diagonal pliers, wire-stripping pliers, and wire clippers

• Meters and equipment such as hub and multimeter

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 120 121

Komentarze do niniejszej Instrukcji

Brak uwag

HP 8800 Router Series Instrukcja Instalacji Strona 8

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking HP 8800 Router Series