HP Modular Cooling System Podręcznik Użytkownika Pobierz pdf (Strona 33)

Web interface 33

Click Clear Alarms to clear the alarms.

NOTE: To clear the condensation pump cycles warning, click Cooling System in the left

navigation frame to access the Cooling System screen, and then click the Alarms/Warnings

tab. Under the Warnings section, set Alarm Reset to Manual and click Save Settings. Then,

return to the General menu and click Clear Alarms.

This step only clears the warning when the condensation pump is not running.

11. Click Reset to Factory Defaults to reset the parameters to the defaults set by the factory. You are

prompted to reboot.

o Click Restart to restart the management module.

o Click Cancel to undo the changes.

Network menu

Click Network in the left navigation frame to access the Network screen. This screen enables the Admin to

configure network settings for the management module.

To set a static IP:

1. Disable DHCP (by default, DHCP is enabled) using the DHCP radio button.

2. Click Save Settings.

3. Change the IP address in the IP Address field of the management module.

4. Change the network mask of the management module.

5. Change the default gateway of the management module.

6. Click Save Settings.

7. Log in to the web interface using the new IP address or hostname.

8. Continue to the next section.

To configure the network settings:

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 57 58

Brak uwag

HP Modular Cooling System Podręcznik Użytkownika Strona 33