HP 2000CP 2500CP Instrukcja Użytkownika Pobierz pdf (Strona 291)

8-70 Removal and Installation

HP DesignJet CP Series Printers

Installation of the drive roller

Note: Make sure all the pincharm assemblies (item 11) are in the

correct position before performing the next step.

1. Install the drive roller (item 10). Make sure the bearings at either end of

the drive roller are installed into the correct position in the left and right

hand side chassis.

2. Install the shoulder screw (item 6) securing the cluster gear (item 7) to

the chassis.

3. Install the following:

1. Service Station Assembly  page 8-26.

2. X-Axis Motor Assembly  page 8-45.

Installation of the overdrive assembly

4. Install the overdrive assembly (item 9) by holding both ends and sliding

the left end first through a sleeve bearing (item 12) into the mount block

(item 13).

5. Install two T-10 screws (item 8) securing the overdrive assembly to the

left and right hand side chassis.

6. Install the clutch (item 4) and two washers (item 5) on the left end of the

overdrive shaft, then secure with the retaining clip (item 3).

7. While pressing down on the roller support bracket, install two T-15

screws (item 1) securing the roller support bracket to the chassis.

8. Install the top half of the elevator assembly by securing it to two

retaining clips at the back and push down and to the right.

9. Install the following:

1. Cutter Assembly  page 8-48

2. Bail Arm Assembly  page 8-58

3. Right Hand Cover  page 8-21.

4. Left Hand Cover  page 8-18.

5. Window and Top Cover  page 8-15.

10.Connect the power cord and turn the printer on in service mode.

11.Perform following calibrations:

1. C08 Service Accuracy Calibration  page 5-17.

12.Perform following service tests:

1. D11 Bail Service Test  page 5-12

2. D05 Service Station Service Test  page 4-16

1 2 ... 286 287 288 289 290 291 292 293 294 295 296 ... 347 348

Brak uwag

HP 2000CP 2500CP Instrukcja Użytkownika Strona 291