Hp Hitachi Dynamic Link Manager Software Instrukcja Użytkownika Strona 289

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 288
3. Creating an HDLM Environment
265
If the Oracle command oracleasm is executed for HDLM devices, the
KAPL05023-E message might be output to syslog.
If the following message indicating the successful completion of the
oracleasm
command is output after this message, there is no problem with HDLM operation.
oracleasm: succeeded
If you use HDLM with Oracle RAC 10g or Oracle RAC 11g and use ASMLib of
Oracle RAC 10g or Oracle RAC 11g, you must change the settings for the
ASMLib configuration file.
After installing ASMLib, do the following for each node:
1. Execute the following command to create the ASMLib configuration file:
# /etc/init.d/oracleasm configure
2. Open the ASMLib configuration file (/etc/sysconfig/oracleasm).
3. Change the
ORACLEASM_SCANORDER line as follows:
ORACLEASM_SCANORDER ="sddlm"
If an ASM disk defined in an HDLM device already exists, perform this
procedure, and then restart all the nodes.
This step must be done to enable the settings.
If you use HDLM with Oracle RAC 11g Release 2, shared file systems, which are
created by using ADVM (ASM Dynamic Volume Manager) or ACFS (ASM
Cluster File System), cannot be used for the archived REDO log file area.
Przeglądanie stron 288
1 2 ... 284 285 286 287 288 289 290 291 292 293 294 ... 745 746

Komentarze do niniejszej Instrukcji

Brak uwag